this was my first try at it.
| BBNovaRacing.com http://www.bbnovaracing.com/forum/ |
|
| this plumbing look ok? http://www.bbnovaracing.com/forum/viewtopic.php?f=1&t=14436 |
Page 1 of 2 |
| Author: | jacobgiles [ Apr Sat 05, 2008 5:55 pm ] |
| Post subject: | this plumbing look ok? |
this was my first try at it.
|
|
| Author: | underdog [ Apr Sat 05, 2008 6:16 pm ] |
| Post subject: | |
Alot better than the first time I did it 
|
|
| Author: | jacobgiles [ Apr Sat 05, 2008 7:08 pm ] |
| Post subject: | |
the intake was drilled when i got it, they are not centered because the guy was going to add a second set of nozzles. |
|
| Author: | $$$Pitt [ Apr Sat 05, 2008 8:03 pm ] |
| Post subject: | |
I think it looks great Jacob. Nice job 
|
|
| Author: | bbnova [ Apr Sat 05, 2008 10:03 pm ] |
| Post subject: | |
Nice job..... One question though... Were's the other carb go????? 
|
|
| Author: | jacobgiles [ Apr Sat 05, 2008 10:20 pm ] |
| Post subject: | |
|
|
|
| Author: | bfnjz52 [ Apr Sun 06, 2008 8:15 am ] |
| Post subject: | |
Lookin' Good! |
|
| Author: | Maliboost [ Apr Sun 06, 2008 8:32 pm ] |
| Post subject: | |
I dont think thats gonna work very well, I would suggest that you pack it up & ship it to me. I could beat on it for a while & get all the bugs worked out for you. LOL. seriously, looks bitchen. Bob |
|
| Author: | Jim Gorski [ Apr Tue 08, 2008 10:28 am ] |
| Post subject: | |
Looks good Jacob |
|
| Author: | bbnova [ Apr Tue 08, 2008 11:20 am ] |
| Post subject: | |
Jacob, have you found a hood scoop to fit that in yet?????? 
|
|
| Author: | jacobgiles [ Apr Tue 08, 2008 7:26 pm ] |
| Post subject: | |
i finally got a cowl hood for the car. |
|
| Author: | bbnova [ Apr Tue 08, 2008 9:25 pm ] |
| Post subject: | |
Does the fogger fit under it???? |
|
| Author: | jacobgiles [ Apr Tue 08, 2008 11:04 pm ] |
| Post subject: | |
im sure it will, i guess i should have bent the nitrous lines to fit tight. |
|
| Author: | underdog [ Apr Wed 09, 2008 5:58 am ] |
| Post subject: | |
IF not, just do what I've seen done before..............Hole Drill for the solenoids to fit through
|
|
| Author: | bbnova [ Apr Wed 09, 2008 6:58 am ] |
| Post subject: | |
Measure the soleniods and measure your cowl hood width.. I'm sure it's ok.... |
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|